What is the layout method of the flatness of the main beam of the single beam crane?

The load-bearing beam of the single-girder crane is not leveled, which immediately affects the subsequent production and processing. First, before moving on to the next whole process, we'll address the flatness of the chief ray. The length of the subsequent sandblasting and electroplating process will result in a whiter and flawless product. However, the structural characteristics of the load-bearing beams of different bridge cranes are different. We must first master the following two points of the device:

At this stage, there are two ways to solve the plane of the load-bearing beam of the single-girder crane equipment:

1. The application of technical mechanical equipment is to remove the convex part of grinding and polishing through laser cutting and plastic deformation of the raw material surface to obtain a lubricated surface grinding and polishing method, and generally use terrazzo, polishing agent, etc.

2. Electropolishing, electropolishing is to make the data information in the chemical substance, the external economic convex part of the local convexity preferentially melt, so as to obtain a bright surface layer. The specific feature of this method is that complex product workpieces can be ground and polished without complex equipment, and many thick steel plates can be ground and polished at the same time. The case of electropolishing is the use of polishing agents and product materials. The surface roughness obtained by electropolishing is generally 10 μm.

The above is all about the arrangement of the flatness of the main beam of the single-girder crane. If you want to know more information, please continue to pay attention to us.